Bottle Caps,Perfume Cap,Perfume Spray Caps,Perfume Bottle Top Zhangjiagang XinYe Chemical Sprayer Co., Ltd. , https://www.xinyesprayer.com
First, woodworking engraving machine spindle motor hot:
Solution: Check whether the pump works first, and whether the circulating water is low or not.
Second, feel the motor no strength, can not move:
Solution: Check the circuit and check if the motor line is missing or if the cable is short-circuited.
Third, the motor emits a strange sound:
Solution: Check if the motor is overloaded; there may be a fault inside the motor. Repair or replace it in time. ---Wood carving machine
Fourth, the motor reversal:
Solution: Directly check the motor line for missing phase or reverse the output UVW.
Five, wood engraving machine has a shaft does not rotate:
Check whether the corresponding drive block of the woodworking engraving machine is damaged;
Check steps are as follows:
1. Unplug the aviation plug corresponding to the fixed shaft of the wood engraving machine; - Woodworking engraving machine
2. Then insert the actuator on the movable axis and observe the phenomenon. If the moving instructions are normal, if it does not move, it means that the cable or the motor is faulty. If it needs to be replaced in time, it means that the drive block corresponding to this axis of the woodworking engraving machine is damaged and the drive block needs to be replaced.
Briefly describe the four types of common faults in spindle motor of woodworking engraving machine and their solutions