A few days ago, the reporter was informed that Mitsubishi Motors Sales (China) Co., Ltd. filed a plan with the AQSIQ according to the requirements of the Regulations on the Management of Defective Automobile Product Recalls. A total of 107,000 recalls due to safety hazards in the engine system and brake lights. A car, involving the wing god, imported Outlander EX Jinjie, Jinxuan, Lancer EX, Lancer Wing Hao Lu Shen and Ge Randi car. It is reported that this recall of the domestic Mitsubishi Wingshen car was produced from February 10, 2009 to November 14, 2011, a total of 52,247 vehicles; and imported Outlander EX Jinjie, Jinxuan, Lancer EX, Lancer Wing Hao Lu Shen Auto For the period from November 7, 2007 to March 9, 2011, a total of 35,357 vehicles were produced. Mainly due to the problem of the material of the drive belt of some vehicle engine alternators in the range, it may cause the resin pulley to be inclined and worn. After continued use, the drive belt will be damaged and fall off. In turn, the battery may be excessively consumed, the engine may be overheated, and the steering wheel steering force may increase, which may present a safety hazard. In addition, the production date is from January 18, 2007 to August 29, 2009, and the production time is from May 31, 2008 to November 22, 2010. In the installation process of the brake lamp, the assembly work was performed using the working glove with silicone grease, so that a small amount of grease entered the contact portion of the switch, and the heat generated when the switch was turned on was An insulator (silicon oxide) may be formed, so that the brake light switch cannot be turned on, causing the brake light to fail to light, posing a safety hazard. Longlived 201 Stainless Steel Cut Wire Shot are all produced through German craftsmanship with bright, defect-free and pollution-free material. After strict processing like heat treating, wire drawing, electronic spiral cutting, passivation molding and other processes, our products are strictly in a accordance with German Spring Association standard VDFI8001, German industrial standards DIN8201 and American Aerospace Material Specification Standard. It is widely used for surface shot blasting, sand blasting and shot blasting of stainless steel parts, aluminum alloy die castings, and copper alloy parts. According to different composition, stainless steel is classfied several grades such as 304, 410, 430, 201 and 201 stainless steel Cut Wire Shot is the most popular abrasive of them as its excellent performance. The composition of 201 stainless steeel is: C≤0.15, Cr 14.00-16.00, Ni 3.50-5.50, Mn ≤5.50-7.50, P≤0.060, S≤0.030, Si≤1.00. So you can check if 201 Stainless Steel Shot could meet your requirement. Generally 201 stainless tseel cut wire shot could be classfied two kinds. One is as cut and the other is conditioned. Compared with as cut one, conditioned is without sharpe edges and corners and has near round shape. According to this, you can choose the more suitable one. 201 Stainless Steel Shot,Sus201 Stainless Steel Shot,Ss201 Stainless Steel Shot,Cut Wire Shot Of Metal Abrasive Longlived Metal Products Co ., Ltd , https://www.tzlonglivedmetal.com