But things are not as serious as the theory. The wheels are exposed. The current brake system's level of technology is sufficient to cope with the braking load caused by the normal driving of the vehicle, even if you often brake you in a big way. It is also possible to choose brake pads that are more resistant to high temperatures, and brake discs to replace the original ones, thereby further increasing the braking capacity. Product introduction
For bending steel bars of various diameters, there are several holes on the work plate to insert the bending pin shaft, and the center pin shaft of different diameters can be replaced accordingly.
Advantages of characteristics Stirrup Bender,Stirrup Bending Machine,Automatic Stirrup Bender,Rebar Stirrup Bending Machine Shandong Luteng Building Equipment Co., Ltd. , https://www.lutengmachinery.com
Steel bending machine, one of steel reinforcement processing machinery.
The working mechanism is a horizontal working disk rotating on the vertical axis. The steel bar is placed in the dotted line position in the diagram. The supporting shaft is fixed on the machine tool.
Applicable to all kinds of round steel, carbon steel, screw steel.
It has strong operability, high working efficiency, convenient Angle adjustment and neat bending
Operation procedures of steel bending machine:
1. Check whether the mechanical performance is good, keep the working table and bending machine surface level;
And prepare various spindle tool blocks.
2. According to the requirements of the diameter of steel bar and bending machine, the core shaft, forming shaft, iron shaft or variable structure shall be installed. The core shaft diameter shall be 2.5 times of the diameter of steel bar.
Check the core shaft, block and turntable shall be free of damage and crack, and the protective cover shall be tightly fixed and reliable, and the operation shall not be performed until it is confirmed that the air machine is running normally.
Iv. During the operation, insert the bend end of the steel bar into the clearance provided by the turntable for fixation, and fix the other end close to the fuselage and press it with your hand to check the fuselage fixation.
The side that actually holds the steel bar can be moved.
It is strictly forbidden to change the spindle, change the Angle, adjust the speed and so on.
When bending steel reinforcement, it is strictly forbidden to process steel reinforcement diameter, root number and mechanical speed beyond the mechanical specification.
When bending high hardness or low alloy steel bars, the maximum limit diameter shall be changed according to the mechanical nameplate, and the corresponding mandrel shall be replaced.
8. It is strictly forbidden to stand in the working radius of the bending steel bar and the unfixed side of the fuselage.
Curved semi - finished products should be stacked neatly, curved hooks should not face up.
When the turntable is turned, it must be done after it has stopped.
X. completion of operation, cleaning of site, maintenance of machinery, power off lock box.
The vast majority of vehicles in use employ disc brakes, which are the entire process in which the brake clips apply braking force to the brake discs through the brake pads. As the horsepower of the automobile engine continues to increase, the requirements for vehicle braking are also required. Higher and higher, where the highest heat concentration is in motion is braking in addition to the engine, but it is also very important for its ventilation and cooling. If the temperature of the braking system is too high, it may cause brakes to become dull or even malfunction. ( If the car can not stop but it is a troublesome thing ah). The current modified vehicles are often piled up in the front of the car a lot of items, shoddy large enclosures, large INTERCOOLER, OIL COOLER, these things to some extent blocked the drive The airflow through the front of the vehicle may affect the braking effect.