he Molded Graphite blocks produced by our company are also called Carbon Graphite Blocks, which can be divided into extruded graphite blocks, extruded graphite squares, molded graphite blocks, molded graphite blocks, Isostatic Graphite blocks, and graphite blocks according to different processing procedures. Different particle sizes can be divided into: fine-grained graphite block, graphite square, medium and coarse-grained graphite block, graphite square, coarse-grained graphite block, etc. Strong chemical stability, high temperature resistance, corrosion resistance, strong lubricity, long service life, can be customized according to customers. Needs to be customized according to size. Molded Graphite,Large Graphite Block,Molded Graphite Block,Carbon Graphite Block CARBONS TECH&CREATION(HENAN) INDUSTRY CO.,LTD , https://www.carbongraphitepart.com
Henan Kaiyuan special high-purity graphite manufacturer, Large Graphite Block, the use of molded graphite block: widely used in refractory materials and coatings in the metallurgical industry, stabilizers for industrial pyrotechnic materials, pencil leads in light industry, carbon brushes in electrical industry, and batteries in battery industry. Electrodes, fertilizer industry catalyst additives, etc. After deep processing, high-purity graphite can also produce high-tech products such as graphite milk, graphite sealing materials and composite materials, graphite products, and graphite anti-friction additives, which have become important non-metallic mineral raw materials in various industrial sectors.
Whether steam traps operate properly or not largely affects the performance and efficiency of steam-powered equipment, including curing presses. At the same time, it also affects the service life of these devices, sometimes causing unexpected accidents and causing huge losses to the enterprises. Therefore, the selection of a trap is very important and should be selected from the following performance bidding of steam traps: (1) Capability to discharge saturated water and supercooled steam Turn into saturated water after releasing heat. If the trap can be saturated water discharge, fresh steam timely replenishment into the vulcanizing machine makes the device always maintained at a higher temperature, can improve production efficiency and product quality. Free float, lever float, float trap can be drained saturated water, undercooling 0-2 ℃. Undercooling refers to the absolute value of the difference between the temperature at which the steam trap can continuously discharge the thermal condensation water and the saturation temperature under the corresponding pressure. Drainage of saturated water drains can be drained at point C, not drained of saturated water traps can only drain at point E, the temperature difference between points C and E is called subcooling. Disc, bimetal, corrugated pipe and other traps can not be discharged due to the high degree of supercooling saturated water is not suitable for vulcanizing machine. (2) The back pressure rate of the trap is also an important indicator of the work of the trap. High back pressure, condensate can be recovered when the back pressure is still high in the case of normal work. (3) trap has a check function, allowing a single vulcanizer to stop working to prevent the flow of condensate back to the vulcanizer adversely affected, resulting in failure, affecting the service life. (4) Select the trap that can be used to overheat the steam. (5) to continuous drainage, and displacement, long life traps. Choosing steam traps can save a lot of energy and capital, of course, perhaps a one-time investment larger, but in the long run is cost-effective, both to ensure product quality, but also can greatly improve work efficiency.