Accurate Digital Thermometer For Baby Health 1. Fast 1 minute readout How to take your temperature 1. Press ON/OFF button to activate. The unit would beep and display. This LCD display test will go on for around 2 seconds. If you press ON/OFF button for more than 2 seconds, the temperature taken last time would be displayed with a ''M'' mark in the right corner. 2. Then, 98.2°F (or 37.0°c) will appear. 3. When L and flashing °F   ( °c ) displays, the thermometer is ready for temperature measuring. But if the room temperature is higher than 89.6 °F  (32.0 °c ), the room temperature would be displayed instead of L . 4. The beep will sound when temperature measuring is complete. 5. Press ON/OFF button to turn off the unit. The unit will automatically power off after approximately ten minutes after use. Place the probe tip under the tongue as near as possible to the heat pocket. Approximate measuring time: 1 minute. Wipe the underarm with a dry towel and place the probe tip under the arm so the tip is touching the skin with the thermometer perpendicular to the body. Position the arm across the chest so the probe tip is well covered by the arm. Approximate measuring time: 2-3 minutes. Note: Axillary temperatures are generally 1.0 °F  /0.5 °c lower than oral readings. 3. Taking a rectal temperature Apply a water-soluble lubricant to the probe cover. Gently insert the probe (MAXIMUM 1/2'') into the rectum. Approximate measuring time: 1 minute. Note: Rectal temperatures are generally 1.0 °F  / 0.5 °c higher than oral readings Before and after each use, clean the thermometer with a soft cloth and isopropyl alcohol diluted with water, or wash with COLD soapy water.. Do not soak for an extended period of time or sterilize by boiling method, gas or steam autoclaves. Accurate Digital Thermometer For Baby Health 1. Fast 1 minute readout How to take your temperature 1. Press ON/OFF button to activate. The unit would beep and display. This LCD display test will go on for around 2 seconds. If you press ON/OFF button for more than 2 seconds, the temperature taken last time would be displayed with a ''M'' mark in the right corner. 2. Then, 98.2°F (or 37.0°c) will appear. 3. When L and flashing °F   ( °c ) displays, the thermometer is ready for temperature measuring. But if the room temperature is higher than 89.6 °F  (32.0 °c ), the room temperature would be displayed instead of L . 4. The beep will sound when temperature measuring is complete. 5. Press ON/OFF button to turn off the unit. The unit will automatically power off after approximately ten minutes after use. Place the probe tip under the tongue as near as possible to the heat pocket. Approximate measuring time: 1 minute. Wipe the underarm with a dry towel and place the probe tip under the arm so the tip is touching the skin with the thermometer perpendicular to the body. Position the arm across the chest so the probe tip is well covered by the arm. Approximate measuring time: 2-3 minutes. Note: Axillary temperatures are generally 1.0 °F  /0.5 °c lower than oral readings. 3. Taking a rectal temperature Apply a water-soluble lubricant to the probe cover. Gently insert the probe (MAXIMUM 1/2'') into the rectum. Approximate measuring time: 1 minute. Note: Rectal temperatures are generally 1.0 °F  / 0.5 °c higher than oral readings Before and after each use, clean the thermometer with a soft cloth and isopropyl alcohol diluted with water, or wash with COLD soapy water.. Do not soak for an extended period of time or sterilize by boiling method, gas or steam autoclaves.
A Solenoid Valve is an electromechanically operated valve. The valve is controlled by an electric current through a solenoid: in the case of a two-port valve the flow is switched on or off; in the case of a three-port valve, the outflow is switched between the two outlet ports. Multiple solenoid valves can be placed together on a manifold.
Solenoid valves are the most frequently used control elements in fluidics. Their tasks are to shut off, release, dose, distribute or mix fluids. They are found in many application areas. Solenoids offer fast and safe switching, high reliability, long service life, good medium compatibility of the materials used, low control power and compact design.
Besides the plunger-type actuator which is used most frequently, pivoted-armature actuators and rocker actuators are also used.
Solenoid valve designs have many variations and challenges.
Common components of a solenoid valve:
The core or plunger is the magnetic component that moves when the solenoid is energized. The core is coaxial with the solenoid. The core's movement will make or break the seals that control the movement of the fluid. When the coil is not energized, springs will hold the core in its normal position.
The plugnut is also coaxial.
The core tube contains and guides the core. It also retains the plugnut and may seal the fluid. To optimize the movement of the core, the core tube needs to be nonmagnetic. If the core tube were magnetic, then it would offer a shunt path for the field lines. In some designs, the core tube is an enclosed metal shell produced by deep drawing. Such a design simplifies the sealing problems because the fluid cannot escape from the enclosure, but the design also increases the magnetic path resistance because the magnetic path must traverse the thickness of the core tube twice: once near the plugnut and once near the core. In some other designs, the core tube is not closed but rather an open tube that slips over one end of the plugnut. To retain the plugnut, the tube might be crimped to the plugnut. An O-ring seal between the tube and the plugnut will prevent the fluid from escaping.
The solenoid coil consists of many turns of copper wire that surround the core tube and induce the movement of the core. The coil is often encapsulated in epoxy. The coil also has an iron frame that provides a low magnetic path resistance.
Solenoid Valve Electromagnetic Valve, Pneumatic Component, Pneumatic Solenoid Valve, Air Compressor Valve,Solenoid Valve Timer NINGBO BRANDO HARDWARE CO.,LTD , http://www.brandopneumatic.com
2. Dependable accuracy ±0.1 °cÂ
3. Lcd display, easy to read, beeping
4. Flexible Tip
5. Cartoon Animal Shapes
6. Color of the cartoon shapes can be customized, if you want wholesale our product, we can offer it with our available package.
Digital Thermometer Details
Measuring range
32.0ºC-42.0ºC(90.0ºF-107.6ºF)
Measuring accuracy
±0.1ºC (±0.2ºF)
Measurement time
60±10seconds in oral 100±20 seconds underarm(for reference only, it differs from people to people)
Min scale
0.1
Beeper fuction
YES
Memory
Last measuring reading
Automatic power off
YES
Battery
1.5V button bttery
packing
1pc/plastic box+paper box.
Weight
11g/pcs
MEAS
58*37*63cm
Waterproof
YES
Low voltage warning
YES
Here are our new hot sell animal digital thermometer for your choice, you can purchase our product with blister card package, like the photo showing:
1. Taking an oral temperature
2. Taking an axillary temperature (under the arm)General Care
Cleaning instructions
2. Dependable accuracy ±0.1 °cÂ
3. Lcd display, easy to read, beeping
4. Flexible Tip
5. Cartoon Animal Shapes
6. Color of the cartoon shapes can be customized, if you want wholesale our product, we can offer it with our available package.
Digital Thermometer Details
Measuring range
32.0ºC-42.0ºC(90.0ºF-107.6ºF)
Measuring accuracy
±0.1ºC (±0.2ºF)
Measurement time
60±10seconds in oral 100±20 seconds underarm(for reference only, it differs from people to people)
Min scale
0.1
Beeper fuction
YES
Memory
Last measuring reading
Automatic power off
YES
Battery
1.5V button bttery
packing
1pc/plastic box+paper box.
Weight
11g/pcs
MEAS
58*37*63cm
Waterproof
YES
Low voltage warning
YES
Here are our new hot sell animal digital thermometer for your choice, you can purchase our product with blister card package, like the photo showing:
1. Taking an oral temperature
2. Taking an axillary temperature (under the arm)General Care
Cleaning instructions
Model NO.: HL-100-1
Type: Electronic Thermometer
Trademark: KINGSUN/OEM
Transport Package: Cartons, Pallet
Specification: 123*20mm(L*W)
Origin: China
HS Code: 9025199090
Model NO.: HL-100-1
Type: Electronic Thermometer
Trademark: KINGSUN/OEM
Transport Package: Cartons, Pallet
Specification: 123*20mm(L*W)
Origin: China
HS Code: 9025199090
The thermometer should only be used under the supervision of an adult.
Do not walk, run or talk during temperature taking.
Store the unit in the protective case when not in use.
Do not store the unit where it will be exposed to direct sunlight, dust or humidity. Avoid extreme temperatures.
Dropping or subjecting your thermometer to strong shocks should be avoided.
Do not attempt to disassemble the unit, except to replace the battery.
The thermometer should only be used under the supervision of an adult.
Do not walk, run or talk during temperature taking.
Store the unit in the protective case when not in use.
Do not store the unit where it will be exposed to direct sunlight, dust or humidity. Avoid extreme temperatures.
Dropping or subjecting your thermometer to strong shocks should be avoided.
Do not attempt to disassemble the unit, except to replace the battery.