Introduction:
This
tool is designed for accurate parking. if you have a problem with the
appraisals, how far is the automobile from the wall when the park, you can use
this device to avoid collision. the ultrasonic technology, which works
automatically. let you know the sound and the three led lights. is a 9v battery
(6f22) or an external source that provides a dc voltage of 9v. it consists of a
display unit, a sensor unit and a cable. it also has low battery indication.
Appearance:
1. ultrasonic hole
2. the
switch
3. the
input jack (external power supply)
4. red
ice
5. the
yellow led
6. the
green ice
7. the
hummer
Installation:
According to figures 2 and 3 include
imaging and sensor unit on the wall. the imaging unit should be attached so
that her driver knew. the sensor unit is mounted directly below the display,
typically 0.7 to 0.9 metres above the ground. Different vehicles may lower the sensor
unit at different locations. a small adjustment may be necessary.
Make sure it's an ultrasonic aperture at
the same level as the bumper or the license plate to the ultrasound reflected
back to the sensor unit.
After the completion of the installation,
try parking your car using the apparatus to make sure that it is installed
correctly.
Note:
1. the cable should
be firmly connected to the sensor and a display unit.
2. make sure that a
sensor unit is no obstacle, which could get in the way of ultrasound.
Picture 2 Picture 3
ultrasonic aperture is at the same
height as a buffer the imaging unit should be
attached t to the driver can see
or license plate
The operating instructions
1.
turn on the machine.
3.
when the distance between the sensor unit and the car between 0.4 m and about 5
m:
a. And on ice and apparatus make a sound when the
automobile approaches the unit.
Note:
the frequency of the alarm buzzer is constant, the distance between the car and
the sensor unit less than approximately 0.5 m. if the distance between
approximately 0.5 m and about 5 m, the frequency of the alarm buzzer varies
with distance. the shorter the distance, the higher the frequency of the alarm
buzzer.
b.
the buzzer will issue a beep, and then shuts down when the car stops to move
toward the sensor unit or when the automobile stops to move to the sensor unit
and begins to move away from her.
c.
the machine lights up ice and turns off the sound when the automobile is moving
from the sensor unit.
d.
the apparatus off ice for approximately 20 seconds after the automobile is
parked.
4.
the machine stops any indication about after 20 seconds, if the distance
between the vehicle and the sensor unit is less than 0.4 m. if the car is
moving from the sensor units and is about 0.4 m far away from her, the buzzer
will issue a beep, and then shuts down.
Notes:
1. the machine can work continuously and
automatically. if it is not long time to use, remove the battery or the
external power supply.
2. when you use the machine, make sure there are no sources in the
vicinity of the ultrasound.
3. use the device only in dry and clean the garage, in which there is no
draft.
4. do not open the machine before the machine off. to prevent electric
shock.
5. if entering the garage the car is going too fast, it may reduce the accuracy.
6. do not use the appliance when the casing is disconnected or the
battery or part of the housing.
7. do not use the apparatus in the vicinity of explosive gases, vapours
or dust.
8. the maximum detection capacity of the apparatus is 5 meters.
The exchange of the battery:
If the buzzer to sound and three led flashing
at the same time, you should immediately to replace the battery. Before the exchange battery device
turn off and unplug the external power supply.
Remove the
batteries and the rear side of the sensor unit, replace a dead battery in a
same type.
Battery back cover
back.
The basic
specifications:
Low battery
indication: the three led at the same time, buzzer and flashing.
Power: 9v battery
(6f22 or equivalent) or an external source two 9v.
Working
temperature: 32 today when 50°c, air humidity < 75%.
Storage
temperature: - 50 degrees to 135, air humidity < 85%.
Size: display: 185
x 61 x 31 mm.
The sensor unit: 82
x 61 x 37 mm. weight: approximately 180 g (without battery)
Notes:
1. the content of
this manual may be changed without notice.
2. the manufacturer
does not assume responsibility for any loss.
3. the contents of
this manual may be used j
Park Indicator Park Indicator,Park Sensor,Sensor Parking,Parking Sensors Shenzhen Cartrend Technology Co, Ltd , https://www.cartrendthings.com
Focusun Sea water flake ice makers are divided into four major categories, including small capacity flake ice machine (daily production ranging from 500 kg -2, 500 kg), medium capacity flake ice machine (daily production ranging from 3, 000 kg - 20, 000 kg), large capacity flake ice machine (daily production ranging from 25, 000, -60, 000) and containerized flake ice making plants (two models: 20-foot standard container and 40-foot standard container).
Configuration: The design meets with the standard of the classification society. The use of one or more Bitzer (oil) semi-hermetic piston compressor accords with sea water cooling and sea water condenser. All parts are welded together. So it is strong enough to run normally even in a pitching and rolling ship.
Features: Designed for navigation system operation, it overcome the seawater corrosion and the ship's pitch
The advantages of flake ice as follows:
Irregular ice flakes with size about 40× 40mm and thickness around 1.5-2.5mm.
The thin ice can be directly used for stirring and mixing refrigerated materials;
No acute edges and corners so it will not damage the surface of the cooled object;
Large contact area and fast cooling speed;
Easy to crush and mold.
Please contact us if you are interested in our Sea Water FLAKE ice machine, we can supply from 0.5ton/day to 60ton/day. And we provide perfect turnkey solution.
Turnkey Solution
As the most professional ice making plant supplier in China, Focusun can systematically provide customers with a series of comprehensive ice-making solutions. Once you have the idea of building an ice-making project, if necessary, our experienced engineers will provide you with professional projects proposals.
Generator
In many countries around the world, electricity use is limited due to many reasons such as the electricity price, voltage stability, the continuity of power supply and other factors. As a result, the diesel generator is your best choice. Choosing a suitable diesel generator as your power source for your ice maker, or as a standby power equipment is the sufficient condition to ensure the effective and quick start of a ice-making project.
Our technical engineers are willing to recommend the suitable diesel generator for you according to your ice-making capacity.
Subject
Unit
Technical parameter
Power supply
Voltage/Phase/Frequency
380V/3P/50Hz
Refrigerant
Â
R22 or R404A
Capacity
Kg/day
4500
Cooling way
Â
Seawater cooling
Temperature
Ambient temperature
Celsius deg
35
Waterinlet temperature
Celsius deg
20
Compressor
Manufacturer
Â
Bitzer
Refrigeration capacity
Kw
27.7
Operating power
Kw
15.29
Compressor COP/EER
Kw/kw
1.81
Horse power
Hp
30
Operating power
Total running power
Kw
17.28
Installment power
Kw
22
Operating power of reducer
Kw
0.37
Operating power of cold water pump
Kw
0.12
Cooling water pump
Kw
1.5
Dimension
Size of ice maker
(L×W×H)(mm)
2200×1050×1550
Size of water feeding pipe
Â
1/2"
Size of ice outlet
mm
Φ720
Weight of unit
Operating weight of flake ice machine
Kg
860
Water supply pressure requirement
Bar
1
Â
Perfect Service System:
All Focusun ice machines come out with 15 months full warranty. If the machine breaks down in 15 months, Focusun will send the parts for free, even send the technician over if situation needed. When beyond the warranty, Focusun will supply the parts and service only for factory cost.
Â
Process:
Please provide the copy of Sales Contract and describe the problems appeared.
Problems confrimation:
Slight problem:
Please send the proof to our After-Sales Department, we will reply within two days.
Serious problem:
Â
A
We will dispatch our Quality and Problems Appraisers to make a confirmation.
B
Have a negotiation of the compensation and sign agreements
C
Our After-Sales Department will perform the duties as the agreement
3. an ultrasonic aperture should be at the same height as a buffer or a
plate.
2. the three led is lit
under the conditions of figure 4. the horizontal axis indicates the distance
between the sensor unit and the car. the sensor unit is in position zero.
Model NO.: FIV-45WS
Ice Shape: Flake Ice
Application Fields: Aquatic Fishery
Certification: CSA, ISO, CE, CCC
Condition: New
Brand Name: Focusun
Daily Capcity: 4500kg
Compressor: Bitzer/Bock/Copeland
Condensation Methods: Air Cooling/Water Cooling
Gas: R404A/R22
After-Sales Service Provided: Engineers Available to Service Machinery Overseas
Trademark: FOCUSUN
Transport Package: Container. Wooden Case
Specification: CE, SGS, ISO 9001, CCC
Origin: Shanghai
Focusun 4.5T/24H Marine Seawater flake ice plant: